HP Press with PLC and Cycle Control

HP PRESS WITH PLC AND CYCLE CONTROL

Hydro-Pneumatic Model HP-16 “H-Frame” Air over Oil Press –
–  Up to 34,000 lbs force at 100 psi air pressure.
–  Air powered – oil sealed unit.
– 4″ Stroke with up to ½” power stroke
–  8” open height (Standard)**
–  20” between columns
–  8” x 10” Precision Ground Platen
– 1.5” diameter ram with 13/16 reamed shank and set screw
–  Includes SS-PB-18 Two-hand Anti-Tie down actuator
– Estimated 10-15 sec. Cycle Time
– Includes: Pressure Return System, programmable logic controller that will allow operator to initiate press to cycle as needed to press part to finish height.

NOTE: Custom tooling package to accommodate customer’s parts, plus guarding and a press stand were also included.